Using The Film Holder - Microtek ScanMaker s350 Start Here Manual

Using the Film Holder

A. To load film:
1. Load the film inside the holder, with
the film's shiny base facing down.
Slide the film along the slots of the
holder until the film is fully loaded.
2. Raise the scanner lid, and place the
film holder with the film on the scan
bed. The holder should be positioned
against the top right edge of the
scanner bed, with the slot for the film
running down the center.
Make sure that the red arrow marks
on both the holder and the scanner
are pointing to each other when the
holder are put together.
B. To load slides:
1. Raise the scanner lid, and place the
film holder on the scan bed. The
holder should be positioned against
the top right edge of the bed, with the
slot for slides running down the
center.
Make sure that the red arrow marks
on both the holder and the scanner
are pointing to each other when the
holder are put together.
2. Place the slide in the film holder, with
the slide facing down.
Do not block
calibration window
(The U-shape
opening at the film
slot side)
Do not block
calibration window
(The U-shape
opening at the slide
slot side)
5