Cable Routing Diagram - Yamaha YZ125(W)/W1 Owner's Service Manual

EC240000

CABLE ROUTING DIAGRAM

1 "ENGINE STOP" button lead
2 Throttle cable
3 Clutch cable
4 Ground lead
5 High tension cord
6 Clamp
7 Air vent hose
8 Radiator breather hose
9 CDI magneto lead
0 YPVS breather hose
q Engine bracket (right)
w Engine bracket (left)
e Crankcase breather hose
r Overflow hose
t Connector cover
CABLE ROUTING DIAGRAM
A Pass the clutch cable on the
outside of the throttle cable and
"ENGINE STOP" button lead.
B Align the throttle cable locating
tape with the cable guide.
C Pass the throttle cable, clutch
cable and "ENGINE STOP"
button lead above the radiator
hose.
D Install the ignition coil, side
core and ground lead together
to the frame. Take care to fas-
ten the ground lead so that its
terminal is within the indicated
range.
E Clamp the throttle cable and
high tension cord to the frame.
2-13
SPEC
F Clamp the clutch cable to the
left engine bracket. Clamp the
clutch cable below the posi-
tioning grommet.
G Pass the air vent hose back of
the throttle cable.
H Pass the air vent hose, over-
flow hose and
breather hose between the
frame and connecting rod.
I Pass
the radiator
hose and YPVS breather hose
outside the engine bracket and
inside the down tube. Then
pass the radiator
hose inside the YPVS breather
hose.
crankcase
breather
breather