Yamaha YZ125(W)/W1 Owner's Service Manual page 456

HANDLEBAR
5. Install:
9 Collar 1
9 Cap cover 2
9 Throttle 3
NOTE:
9 Apply the lithium soap base grease on the
throttle grip sliding surface.
9 Tighten the grip cap bolts temporarily without the
throttle being fixed to the handlebar.
6. Install:
9 Throttle cable 1
To tube guide 2.
NOTE:
Apply the lithium soap base grease on the throt-
tle cable end and tube guide cable winding por-
tion.
7. Install:
9 Roller 1
9 Collar 2
NOTE:
9 Apply the lithium soap base grease on the
roller sliding surface and cable guide.
9 Install the roller so that the "UPPER" mark a
faces upward.
9 Pass the throttle cable in the groove b in the
roller.
8. Install:
9 Throttle cable cap 1
9 Screw (throttle cable cap) 2
9. Adjust:
9 Throttle grip free play
Refer to "THROTTLE CABLE ADJUST-
MENT" section in the CHAPTER 3.
10. Install:
9 Cap cover 1
5-47
CHAS
1 Nm (0.1 m•kg, 0.7 ft•lb)