Front Fork Oil Seal And Dust Seal Cleaning; Front Fork Rebound Damping Force Adjustment; Standart Position - Yamaha YZ250(N)/LC Owner's Service Manual

FRONT FORK OIL SEAL AND DUST SEAL CLEANING/

FRONT FORK REBOUND DAMPING FORCE ADJUSTMENT

EC36D001
FRONT FORK OIL SEAL AND DUST SEAL
CLEANING
1. Remove:
9Protector
9Dust seal 1
NOTE:
Use a thin screw driver, and be careful not to
damage the inner fork tube and dust seal.
2. Clean:
9Dust seal a
9Oil seal b
NOTE:
9Clean the dust seal and oil seal after every run.
9Apply the lithium soap base grease on the in-
ner tube.
EC36H002
FRONT FORK REBOUND DAMPING FORCE
ADJUSTMENT
1. Adjust:
9Rebound damping force
By turning the adjuster 1.
Stiffer a a
Increase the rebound damping
force. (Turn the adjuster 1 1 in.)
Softer b b
Decrease
damping force. (Turn the
adjuster 1 1 out.)
Extent of adjustment:
Maximum
Fully turned in
position
9STANDARD POSITION:
This is the position which is back by the spe-
cific number of clicks from the fully turned-in
position.
Standard position:
12 clicks out
*13 clicks out
*For EUROPE
3-27
INSP
ADJ
the rebound
Minimum
20 clicks out
(from maximum
position)