Yamaha YZ250(N)/LC Owner's Service Manual page 304

KICK AXLE, SHIFT SHAFT AND PRIMARY DRIVE GEAR
6. Install:
9Bolt [crankcase cover (right)] 1
NOTE:
Tighten the bolts in stage, using a crisscross
pattern.
7. Install:
9Kick starter 1
9Plain washer 2
9Bolt (kick starter) 3
NOTE:
Install the kick starter closest to but not contact-
ing the clutch cover mounting boss a.
8. Install:
9Shift pedal 1
9Bolt (shift pedal) 2
NOTE:
Install the shift pedal so that the top of the shift
pedal outer diameter a is highest without
exceeding the line b connecting the center of
the shift shaft and bottom of the screw
[crankcase cover (left)] 3.
4-47
ENG
10 Nm (1.0 m•kg, 7.2 ft•lb)
30 Nm (3.0 m•kg, 22 ft•lb)
10 Nm (1.0 m•kg, 7.2 ft•lb)