1
TIP
• To maintain the proper wheel alignment, ad-
just both sides evenly.
• Push the rear wheel forward to make sure that
there is no clearance between the swingarm
end plates and the ends of the swingarm.
d. Tighten the locknut.
Locknut
21 Nm (2.1 m·kgf, 15 ft·lbf)
e. Tighten the wheel axle nut.
Wheel axle nut
135 Nm (13.5 m·kgf, 98 ft·lbf)
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
CHECKING THE FRONT FORK LEGS
EAS1SL5101
1. Stand the vehicle upright on a level surface.
EWA13120
WARNING
Securely support the vehicle so that there is
no danger of it falling over.
2. Check:
• Inner tube
Damage/scratches Replace.
• Front fork leg (s)
Oil leaks between inner tube and outer tube
Replace the oil seal.
3. Hold the vehicle upright and apply the front
brake.
4. Check:
• Front fork operation
Push down hard on the handlebar several
times and check if the front fork rebounds
smoothly.
Unsmooth operation Correct or replace.
Refer to "FRONT FORK" on page 4-38.
a
b
2
3
CHECKING THE FRONT FORK PROTEC-
EAS1SL5102
TOR GUIDE
1. Check:
TIP
The protector guide reaches the limit of its use
when it is worn down to the same height "a" as
of the outer tube circumference.
CLEANING THE FRONT FORK OIL SEAL
EAS1SL5103
AND DUST SEAL
1. Remove:
ECA?
NOTICE
Be careful not to damage the dust seal and
the inner tube by a driver.
3-28
• Protector guide "1"
Out of specification Replace.
• Protector
• Dust seal "1"
1
CHASSIS
1
a