Yamaha YZ250(N)/LC Owner's Service Manual page 438

FRONT FORK
4. Tighten:
9Pinch bolt (handle crown) 1
9Pinch bolt (under bracket) 2
cC
Tighten the under bracket to specified
torque. If torqued too much, it may cause
the front fork to malfunction.
5. Install:
9Brake hose holder 1
9Caliper 2
9Bolt (caliper) 3
NOTE:
Fit the brake hose holder cut a over the projec-
tion b on the front fork and clamp the brake
hose.
6. Install:
9Brake hose holder 1
9Bolt (brake hose holder) 2
9Protector 3
9Bolt (protector) 4
NOTE:
When installing the brake hose holder, align the
top a of the brake hose neck with the brake
hose holder bottom b. Then pass the brake
hose 5 in front of the axle boss c and fit it into
the hose groove d so that the brake hose does
not contact the nut (wheel axle).
7. Adjust:
9Rebound damping force
NOTE:
Turn in the damping adjuster 1 finger-tight and
then turn out to the originally set position.
5-39
CHAS
23 Nm (2.3 m•kg, 17 ft•lb)
20 Nm (2.0 m•kg, 14 ft•lb)
23 Nm (2.3 m•kg, 17 ft•lb)
10 Nm (1.0 m•kg, 7.2 ft•lb)
10 Nm (1.0 m•kg, 7.2 ft•lb)