Hand Crank Handles; Gloves - Invacare Excelerator Owner's Operator And Maintenance Manual

SECTION 8
HAND CRANK HANDLES (FIGURE 6)
HORIZONTAL HANDLES/
DELRIN HANDLES
1. Secure handle to hand crank with the
screw.
2. Remove the screw to remove handle
from hand crank.
VERTICAL HANDLES
1. Position handle onto crank as shown in
DETAIL "B" of FIGURE 6.
2. Tighten set screw to secure handle to
crank.
3. Reverse STEPS 1-2 to remove handle.
TRI-PIN QUAD HANDLES
1. Refer to VERTICAL HANDLES in this
procedure to remove/install tri-pin
quad handles.
2. Loosen socket screws to adjust handle
position, as shown in DETAIL "C" of
FIGURE 6.
3. Tighten socket screws to secure
handles in desired position.
GLOVES (FIGURE 7)
1. Wrap palm loop around horizontal handle (using top slot only) and secure to
glove.
2. Run glove loop through bottom slot on palm and over back of hand until tight.
Secure glove loop to back of glove.
3. Reattach glove strips to back of glove.
Glove
Glove Strip
Excelerator™Series
Palm Loop Secured to Glove
Top Slot
Palm
Loop
FIGURE 7 - GLOVES
40
DETAIL "A" - HORIZONTAL
HANDLES/DELRIN HANDLES
Hand Crank
Horizontal
Handle
DETAIL "B" - VERTICAL HANDLES
Set Screw
Vertical Handle
DETAIL "C" - TRI-PIN QUAD
HANDLES
Socket Screw
FIGURE 6 - HANDCRANK
HANDLES
Glove
Strip
Horizontal Handle
OPTIONS
Screw
Hand Crank
Tri-Pin
Quad
Handles
Glove Loop
Bottom Slot
Part No. 1056188