Back Upholstery Replacement - Invacare Excelerator Owner's Operator And Maintenance Manual

SECTION 7
BACK UPHOLSTERY REPLACEMENT (FIGURE 7)
Upholstery MUST be inspected BEFORE each use. Exposure to moisture
(ie.- wet weather or puddles) will damage fastening straps/flaps/strips. DO
NOT operate handcycle if upholstery is wet or damaged, otherwise
severe injury may occur.
1. Unlatch the two (2) fastening flaps that secure the bottom of existing back
upholstery to the back canes.
2. Unlatch the top of the existing back upholstery.
3. Lift up on the existing back upholstery and remove from the wheelchair.
4. Install the new back upholstery onto the wheelchair.
5. Securely latch the fastening flaps on the bottom of the new back upholstery to the
back canes.
Fastening Flap
FIGURE 7 - BACK UPHOLSTERY REPLACEMENT
Excelerator™Series
SERVICE PROCEDURES
WARNING
Back Upholstery
36
Fastening Flap
Back Cane
Part No. 1056188