Seat Upholstery Replacement - Invacare Excelerator Owner's Operator And Maintenance Manual

SERVICE PROCEDURES
SEAT UPHOLSTERY REPLACEMENT (FIGURE 6)
Upholstery MUST be inspected BEFORE each use. Exposure to moisture
(ie.- wet weather or puddles) will damage fastening straps/flaps/strips. DO
NOT operate handcycle if upholstery is wet or damaged, otherwise
severe injury may occur.
1. Remove seat cushion and back upholstery from chair.
2. Unlatch the four (4) fastening flaps that secure the seat upholstery to the seat frame.
3. Remove the existing seat upholstery.
4. Install the new seat upholstery making sure that the three (3) fastening flaps that are
in close proximity to one another are to the rear of the seat frame.
5. Secure the four (4) fastening flaps together.
6. Reinstall back upholstery and seat cushion onto chair.
Large Strap Toward Rear
of Seat Frame
Three (3) Seat Upholstery Fastening
Straps Towards Rear of Seat Frame
FIGURE 6 - SEAT UPHOLSTERY REPLACEMENT
Part No. 1056188
WARNING
Back Upholstery
35
SECTION 7
Towards Front of Chair
Excelerator™Series