HP Surestore Tape Library Model 10/180 Configuration Manual page 9

Installing the
Pass-Through
Driver
Class I H/W Path
bc 0
bc 1 8
ba 0 8/0
ext_bus 1 8/0/2/0
target 3 8/0/2/0.0
autoch 2 8/0/2/0.0.0
target 4 8/0/2/0.1
tape 2 8/0/2/0.1.0
target 5 8/0/2/0.2
tape 4 8/0/2/0.2.0
If these drivers are already installed into the kernel, upon system boot
they will automatically be associated with the hardware that they
control. However, if drivers are missing, they must be installed. For
more information on installing Fibre Channel drivers, refer to the
Fibre Channel Mass Storage Adapter Service and User Manual
(A3636-90002)
.
A pass-through driver is used to manage the robotics controller. Since
this driver is not dedicated for this particular device, it must be
manually installed. The following sections describe this process:
Installing the pass-through driver (below)
•
Creating a device file for the robotics controller
•
Verifying the installation
•
Obtain information about the peripherals attached to the system:
ioscan -f
The screen should look similar to the following:
Driver
root
bc
GSCtoPCI
c720
tgt
schgr
tgt
stape
tgt
stape
(page
10)
S/W State H/W Type
CLAIMED BUS_NEXUS
CLAIMED BUS_NEXUS
CLAIMED BUS_NEXUS
CLAIMED INTERFACE
CLAIMED DEVICE
CLAIMED DEVICE
CLAIMED DEVICE
CLAIMED DEVICE
CLAIMED DEVICE
CLAIMED DEVICE
(page
8)
Description
Pseudo Bus
Converter
PCI Bus Bridge -
GSCtoPCI
Ultra Wide SCSI
HP C7200-8000
QUANTUM DLT8000
QUANTUM DLT8000
Configuring the Host System
HP
7