HP Surestore Tape Library Model 10/180 Configuration Manual page 11

Class I H/W Path
autoch 0 10/4/4.6.0
Class I H/W Path
unknown -1 10/4/4.6.0
2. Determine the value for <majornum> by executing the following
command for robotics attached to an HSC or PCI adapter:
lsdev -d sctl
The output resembles the following:
Character
HSC or PCI 203
Determine the value for <minornum> using the ioscan command.
The applicable lines in the ioscan output are those that refer to the
controller (contains the product name in the Description field)
and to the adapter (contains the ext_bus in the Class field).
For the HSC or PCI adapter, the ioscan output for the schgr
driver can differ in two ways, though either indicates successful
device file creation.
If the schgr driver is configured on the system, this driver
•
appears to be associated with the library. The output would
resemble the following:
Driver S/W State
schgr CLAIMED
If the schgr driver is not configured on the system, no driver
•
appears to be associated with the library. The ioscan output
line resembles:
Driver S/W State
UNCLAIMED
Block Driver
-1 sctl
H/W Type
DEVICE
H/W Type
DEVICE
Configuring the Host System
Class
ctl
Description
HP C7200-8000
Description
HP C7200-8000
9