HP Surestore Tape Library Model 10/180 Configuration Manual page 14

12 Configuring the Host System
/4/4.1.0 DLT8000 . . .
/4/4.2.0 DLT8000 . . .
/4/4.3.0 DLT8000 . . .
/4/4.4.0 DLT8000 . . .
3. Boot the system. At the MPE prompt, run sysgen and start the io
section:
sysgen
SYSGEN version E . . .
sysgen> io
** IO configurator commands **
4. If not already configured, configure the differential card and the
pseudo/target level of the SCSI path:
io> apath 10/4/4 id=HP28696A
io> apath 10/4/4.0 id=pseudo
io> apath 10/4/4.1 id=pseudo
io> apath 10/4/4.2 id=pseudo
io> apath 10/4/4.3 id=pseudo
io> apath 10/4/4.4 id=pseudo
5. Configure the robotics controller and the drives (the pass-thru
driver):
io> adev 30 id=HPA4669A path=10/4/4.0.0
io> adev 31 id=DLT8000 path=10/4/4.1.0
mode=autoreply
io> adev 32 id=DLT8000 path=10/4/4.2.0
mode=autoreply
io> adev 33 id=DLT8000 path=10/4/4.3.0
mode=autoreply
io> adev 34 id=DLT8000 path=10/4/4.4.0
mode=autoreply
6. Verify the bindings between PATH, LDEV number, ID, PMGR
(device drivers), and LMGR attributes for each device configured.