Windows Nt4 - HP Surestore Tape Library Model 10/180 Configuration Manual

Windows NT
4 Configuring the Host System
For Windows NT operating systems, perform the following operating
system configurations:
Install the appropriate host bus adapter(s)
•
Install the corresponding drivers for the interface card(s)
•
Install the backup software
•
To verify the installation, look for the library and drive after powering
up the host.
Go into
•
Settings
You can also check your installation on Windows NT with HP
•
diagnostic utilities available from www.hp.com/go/support. See
the
Downloads and Drivers
Run a test backup to ensure that all components are properly
configured.
-> ->
Control Panel
section for your library model.
SCSI Adapter