Configuring Hybrid Mode Vlan Membership; Mac Address Table; Configuring Unicast Static Mac Address - Mellanox Technologies Mellanox SX1018 User Manual

5.3.4

Configuring Hybrid Mode VLAN Membership

 To configure Hybrid mode VLAN membership:
Log in as admin.
Step 1.
Enter config mode. Run:
Step 2.
switch > enable
switch # configure terminal
Create a VLAN. Run:
Step 3.
switch (config) # vlan 10
switch (config vlan 10) #
Change back to config mode. Run:
Step 4.
switch (config vlan 10) # exit
switch (config) #
Enter the interface context. Run:
Step 5.
switch (config) # interface ethernet 1/35
switch (config interface ethernet 1/35) #
From within the interface context, configure the interface mode to Hybrid. Run:
Step 6.
switch (config interface ethernet 1/35) # switchport mode hybrid
switch (config interface ethernet 1/35) #
From within the interface context, configure the allowed VLAN membership. Run:
Step 7.
switch (config interface ethernet 1/35) # switchport hybrid allowed-vlan add 10
switch (config interface ethernet 1/35) #
Change to config mode again. Run:
Step 8.
switch (config interface ethernet 1/35) # exit
switch (config) #
5.4

MAC Address Table

5.4.1

Configuring Unicast Static MAC Address

You can configure static MAC addresses for unicast traffic. This feature improves security and
reduces unknown unicast flooding.
 To configure Unicast Static MAC address:
Log in as admin.
Step 1.
Enter config mode. Run:
Step 2.
switch > enable
switch # configure terminal
Run the command
Step 3.
vlan <vlan identifier(1-4094)> interface ethernet <slot>/ <port>
switch (config) # mac-address-table static unicast 00:11:22:33:44:55 vlan 1 interface
ethernet 0/1
mac-address-table static unicast <destination mac address>
.
Mellanox Technologies
Rev 1.6.2
65