Eth Mgmt - Mellanox Technologies Mellanox SX1018 User Manual

Table 20 - Fabric Inspctr Submenus
Submenu Title
IB Nodes
IB Ports
Connections
System Names
3.2.8

ETH Mgmt

The Eth Mgmt menu is not applicable when the switch profile is not ethernet.
The ETH Mgmt menu makes available the following sub-menus (listed in order of appearance
from top to bottom):
Table 21 - ETH Mgmt Submenus
Submenu Title
Spanning Tree
MAC Table
Link Aggregation
VLAN
IGMP Snooping
ACL
Displays information about InfiniBand nodes in the fabric. It is possible to filter
display by the type of InfiniBand node (HCA adapter, switch, etc).
Displays all active InfiniBand ports in the fabric. It is possible to filter display by
the type of InfiniBand port (HCA port, switch port, switch management port,
etc), by the port rate (speed or width), by the Subnet Manager status on the node,
by node traffic, etc.
Displays all active connections in the fabric. It is possible to filter display by the
link type (switch to switch, switch to HCA, etc) and by the link rate (speed or
width).
Allows the mapping of System Names to GUIDs to ease system identification.
Used for configuring and monitoring spanning tree protocol.
Used for configuring static mac addresses in the switch, and displaying the mac
address table.
Used for configuring and monitoring aggregated Ethernet links (LAG) as well as
configuring LACP.
Used for managing the switch VLAN table.
Used for managing IGMP snooping in the switch.
Used for managing Access Control in the switch.
Description
Description
Mellanox Technologies
Rev 1.6.2
36