Hp Integrity Superdome 2 Onboard Administrator; Remotely Accessing The Onboard Administrator - HP Integrity Superdome 2 16-socket Service Manual

Recommended Action 1 :
Check the XFabric links.
reference. Check for physical damage on the FRU connection points and ensure proper mating/seating occurs.
Check the system error logs for other events describing previous XFabric link failures. If the problem
persists, replace only one FRU at a time in the order given below. Test the system between each FRU
replacement
Replaceable Unit(s) :
Part Manufacturer
Spare Part No.
Part Serial No.
Part Location
Additional Info
Part Manufacturer
Spare Part No.
Part Serial No.
Part Location
Additional Info
Additional Data :
Severity
Alert Type
Event Category
Event Subcategory
Probable Cause
Other Event Subcategory
Event Threshold
Event Time Window
Actual Event Threshold
Actual Event Time Window
LinkType
Local Link Id
Remote Link Id
Redundancy status
OEM System Model
Original Product Number
Current Product Number
OEM Serial Number
Version Info :
Complex FW Version
Provider Version
Error Log Data :
Error Log Bundle
See the HP Integrity Superdome 2 Onboard Administrator Command Line Interface User Guide
for the correct and detailed command syntax. The HR Viewer can also provide help in visualizing
component issues.

HP Integrity Superdome 2 Onboard Administrator

The OA provides diagnostic and configuration capabilities. See the HP Integrity Superdome 2
Onboard Administrator Command Line Interface User Guide for more information on the OA CLI
commands. You can access the OA CLI either from a remote system or locally.
The status logs consist of:
System Event
Forward Progress
Live Events
IMPORTANT:
Onboard Administrator CLI commands POWEROFF XFABRIC followed by POWERON XFABRIC
after re-inserting any blade to ensure they are detected by the OA.
See the HP Integrity Superdome 2 Onboard Administrator Command Line Interface User Guide
for more information on the OA CLI commands.

Remotely accessing the Onboard Administrator

The Onboard Administrator CLI can be accessed remotely through any Telnet or SSH session.
Procedure 1 Telnet session
1. From a network-connected client, open a command-line window.
The FRU's used to implement the link that caused the MCA is included as a
: HP
: AH341-60301
: MYJ01503SK
: 0x0100ff01ff00ff51
: XFabric Link Id : 5
: HP
: AH341-60301
: MYJ01503SK
: 0x0100ff01ff00ff51
: XFabric Link Id : 4
: Fatal/NonRecoverable
: Device Alert
: System Interconnect
: Other
: Transmit Failure
: Fabric Interconnect
: 1
: 0 (minutes)
: 1
: 0 (minutes)
: CONNECTOR
: 5
: 4
: REDUNDANT
: NA
: AH337A
: AH337A
: NA
: 3.5.24
: 5.71
: 072
The XFABRIC should be powered off prior to removing all blades by using the
enclosure1/xfm1
enclosure1/xfm1
Using event logs 79