FRONT BRAKE PAD INSPECTION AND REPLACEMENT
REAR BRAKE ADJUSTMENT/
REAR BRAKE ADJUSTMENT
Brake pedal height a
Out of specification → Adjust.
Brake pedal height a:
4 ~ 10 mm (0.16 ~ 0.39 in)
Brake pedal height
Pedal height adjustment steps:
Loosen the locknut 1.
Turn the adjusting nut 2 until the pedal
height a is within specified height.
Tighten the locknut.
Adjust the pedal height between the
maximum È and the minimum É as
shown. (In this adjustment, the bolt 3
end b should protrude out of the lower
adjusting nut 4 but not be less than
2 mm (0.08 in) c away from the brake
After the pedal height adjustment, make
sure that the rear brake does not drag.
FRONT BRAKE PAD INSPECTION AND
Brake pad thickness a
Out of limit → Replace as a set.
Brake pad thickness:
4.0 mm (0.16 in)
<Limit>: 0.8 mm (0.03 in)
3 - 18