Hydraulic Clutch; Check Oil Level; Bleeding The Hydraulic Clutch - Beta RR 250 Owner's Manual

HYDRAULIC CLUTCH

CHECK OIL LEVEL

To check the oil level in the clutch pump,
fi rst remove cover 2.
Remove the two screws 1 and take off
cover 2 together with the rubber bellows.
With the clutch pump in a horizontal posi-
tion, the level of the oil should be 5 mm
below the upper rim.
If necessary top up with (DOT 5.1) hy-
draulic oil, which is available from your
BETAMOTOR dealer.
BLEEDING THE HYDRAULIC
CLUTCH
To bleed air from the rear clutch pump,
proceed as follows:
•Open the sump cap.
•Insert one end of a transparent tube into
a container.
•Pump with the clutch lever 2/3 times and
keep the lever pressed.
•Unscrew the valve and let the oil drain.
•If are still visible in the tube repeat above
operation until obtaining a continuous
outfl ow of oil within no air bubbles.
•Close the valve and release the lever.
NOTE:
The pump is suitable for bleeding in depres-
sion. During this procedure, continuously
top up the clutch pump thank to replace
the oil that is out fl owing.
•Remove the tube.
41
3
1
2
3
GB