Table of Contents
Advertisement
NetVanta 1235P Hardware Installation Guide
Wall Mounting the NetVanta 1131
The NetVanta 1131 can be mounted on a wall by following these steps:
Step
1
Attach the wallmount brackets so that the portion with the mounting holes is flush with the
bottom of the chassis.
2
Decide on a location for the unit. NetVanta 1131 units are mounted with the front panel facing
left (see
Figure
that the LEDs are visible.
3
Prepare the mounting surface by attaching a board (typically plywood, 3/4-inch to 1-inch thick)
to a wall stud using #6 to #10 (2.5-inch or greater in length) wood screws.
Important! To avoid damaging the unit when attaching the mounting brackets, use only the
screws supplied with the unit.
4
Have an assistant hold the unit in position as you install two #6 to #10 (1-inch or greater in
length) wood screws through the unit's brackets and into the mounted board (see
5
Proceed to the steps given in
page
37.
61700595G10-34A
Instructions for Wall Mounting the NetVanta 1131
10). Keep in mind that the unit needs to be mounted at or above eye-level so
Powering the NetVanta 1131 and the NetVanta Switch on
Figure 10. Wall Mounting the NetVanta 1131
Copyright © 2013 ADTRAN, Inc.
Action
NetVanta 1131 RPS/EPS
Figure
10).
35
Advertisement
Table of Contents
