Table of Contents
Advertisement
Physical Descriptions
NetVanta 1235P Hardware Installation Guide
Extended Power Supply LED
The EPS LED is located on the left side of the unit and indicates when the unit is receiving power from
the EPS.
Link/Activity LED
The LINK/ACT LED is located on the left side of the unit and indicates that the port LEDs are
displaying link/activity status.
Power over Ethernet LED
The PoE LED is located on the left side of the unit and indicates that the port LEDs are displaying PoE
status.
VCID LED (Future Release)
The VCID LED is located on the left side of the unit and indicates that the port LEDs are displaying
VCID.
LED Mode Switch
The LED mode switch is located on the left side of the unit and is used to toggle Ports 1 through 24
between VCID, link/activity, and PoE display modes.
CONSOLE Interface
The CONSOLE interface is an EIA-232 serial port (DCE) that provides local management and
configuration (via a DB-9 female connector). Refer to
Table A-1 on page 39
for pinouts.
Connection directly to an external modem requires a cross-over cable.
10/100Base-T Ethernet Interfaces
The front panel contains 24 10/100Base-T Ethernet interfaces (RJ-45). These interfaces are arranged in
stacked pairs, with the numbers 1 through 24 screened from left to right directly above the
corresponding ports. Status LEDs for each stacked pair of interfaces are located directly over the
interfaces. Refer to
Table A-2 on page 39
for pinouts.
SFP Slots
The front panel contains four industry standard SFP slots for fiber or copper connectivity. These
interfaces are numbered G1 through G4 and their status LEDs are located directly above these
numbers. Refer to
Table A-3 on page 40
for pinouts.
16
Copyright © 2013 ADTRAN, Inc.
61700595G10-34A
Advertisement
Table of Contents
