Making A Connection With Telnet.exe - Yamaha RCX series User Manual

2-10 Making a connection with TELNET.EXE

The following briefly explains how to make a connection using TELNET.EXE. (For details on how
to install TELNET into PCs, see the relevant instruction manual.)
Preconditions are a robot controller IP address of 192.168.0.2, a port No. of 23, and all other dedicated
TELNET parameters at their default values.
1) Click the "Start" button and select "Run" to
open the file name input dialog box.
2) Enter "telnet" in the edit box and then press the
"OK" button.
3) The telnet.exe now starts up. Enter "open
xxx.xxx.xxx.xxx" following the prompt (>) and
then press the Enter key.
In the "xxx.xxx.xxx.xxx" portion, enter the IP
address of the robot controller.
4) Connection is made to the robot controller and
a login check begins.
Enter the user name here and then press the
Enter key.
* If the login check is disabled by the robot
parameter, then this user name request
message and the subsequent password
message do not appear.
5) Next, enter the password.
At this point, the password characters you
entered are displayed as asterisks (*) on the
screen.
After entering the password, press the Enter key.
6) An OK message appears on the screen when
the login check ends normally.
From now on, commands and messages can be
exchanged with the robot.
2-10 Making a connection with TELNET.EXE
2
25