Table of Contents
Advertisement
If you're not satisfied with the image quality, try using a higher
quality original.
7
Can you tell me why a 100 dpi scan resolution takes the
same amount of time as a 200 dpi scan resolution?
Make sure you set the Copier/Copy Mode/Select Mode menu to
Custom before changing the scan resolution. Otherwise, you
can't use the control panel settings for scan resolution.
8
I've set the number of copies in the Copier/Number of Copies
menu to 3, but I still get only 1 copy.
After you set the number of copies, use the Previous key to return
to the Copier/Copy menu, and press the Select key twice to save
the selected number of copies. Unless the number of copies is
saved before you exit from the Copier/Number of Copies menu, it
will be automatically reset to 1.
9
Do I have to scan and print an entire page, if I want to scan
an image only the size of a business card?
No, you need to do the following:
a
Place the image in the upper-left corner of the document
glass (as viewed from the front of the scanner with the glass
open)
b
Access the Copier/Copy Mode/Scan Size menu.
c
Set the Horiz (in. x 100) to about 350 and the Vert. (in. x 100)
to about 200.
The scanner will now only scan the top-left side of the glass
for a width of about the size of a business card.
Note: The scan width translates into inches times 100, so if
»
you want to scan the top 3.5 inches of a document, then set
the vertical size to 350.
L
Advertisement
Table of Contents
