QMS CrownCopy User Manual page 13

n
magicolor CX envelope containing CrownCopy software (on
disks) for the QMS magicolor CX
» Note: Before installing CrownCopy on your printer, you should turn on
the printer, wait for IDLE to appear in the message window, and then
print an advanced status page. (See "The Status Pages" section of
your printer user's guide for advanced status page information.)
This procedure should not change your printer's configuration set-
tings. However, the advanced status page provides a record of all
current configuration settings, so you can verify that they are the
same or recover your settings after installing CrownCopy.
If you have a magicolor CX, skip to step 3.
1
If you have a magicolor LX, place the Select/Copy overlay on
2
the printer's Select key, then update the printer firmware.
This firmware (a PROM) is provided with the CrownCopy kit. For
installation instructions, see "Updating the Printer Firmware" on
page 10 of this chapter.
3 If you added memory in the printer, place the additional
memory in the printer's Emulation memory buffer so Crown-
Copy can use it.
Printer Resolution
(dpi)
300
600
The Emulation buffer is accessed through the printer's control
panel in the Administration/Memory/K Mem Emulation submenu.
Printer RAM (MB)
24
24
32
40
64
Emulation Buffer Size
(KB)
852
1024
4096
10240
27648