QMS Magicolor 2 plus Manual page 34

5 Secure the interface card to the interface panel with the two screws you
removed earlier.
6 Reinstall the controller board.
Gently slide the controller board into the printer until it is fully seated, and then
tighten the two screws.
7 Reconnect all interface cables.
8 Reconnect the power cord, and turn on the printer.
Note: In compliance with UL guidelines, "The appliance inlet is considered to be
»
the main disconnect device."
9 Print a startup page.
Check that the startup page lists the interface (Optional NIC) just installed under
"Options."
Once a network interface is installed, refer to the following for more information:


For a CrownNet interface, refer to the Connecting Your QMS Print System for
information on connecting to the network, installing the software, and configuring
the interface and the network. In addition, chapter 2, "Printer Configuration," of
QMS CrownNet Interface System Administrator's Guide , provides complete con-
figuration information.


For a DECnet-TCP/IP interface, refer to the QMS DECnet-TCP/IP Setup Guide and
the TCP/IP Protocol Option User's Guide .


Your application and network documentation contain information on printing over
the network.
Once a LocalTalk interface is installed, refer to the following for more information:


For configuration information, refer to chapter 4, "Printer Configuration," in the
Reference manual.


Your application and Macintosh documentation contain information on printing via
LocalTalk.