QMS Magicolor 2 plus Manual page 47

If your PC and printer are connected through the serial port, type
copy /b *.ps com #
where # is 1 to 4. (/b refers to binary files.)
5 When the downloading is complete, reboot the printer.
'  )  ( "
» Note: Before you begin this procedure, your printer and PC (or UNIX workstation)
must be connected to an Ethernet network running TCP/IP and have valid IP
addresses.
1 If your PC is running Windows, change to DOS.
2 Insert the fonts disk in your PC's 3.5" disk drive, and change to that drive
(for example, if you're using the A drive, type a: ).
3 If you want to download the fonts from a UNIX workstation, copy the instal-
lation file from the fonts disk to a temporary directory on your UNIX work-
station.
4 Turn on the printer, and wait for IDLE to appear in the message window.
5 Open an ftp session at your PC or workstation by typing one of the following
commands:
ftp printername
ftp ipaddress
6 When prompted for a user name and password, press Enter for both.
An ftp> prompt displays.
7 At the ftp> prompt, change to binary mode by typing
bin
8 At the ftp> prompt, send the fonts file to the printer's hard disk by
typing
put filename .ps
where filename is the name of the installation file.
The printer's message window reads 1 Active Job to indicate that the fonts are
being downloaded to the hard disk. The ftp> prompt returns when the fonts have
finished loading.
(for example, ftp pctdev6 )
(for example, ftp 161.33.130.45 )