Single In-Line - QMS Magicolor 2 plus Manual

Print system
Hide thumbs Also See for Magicolor 2 plus:
Table of Contents

Advertisement

This chapter provides details on how to install RAM and how to update system
software.
 Caution: It's very important to protect the printer controller board and any associated
daughterboard or module from electrostatic damage while performing any task
involving the controller board.
If an antistatic wrist strap is provided in your printer option kit, attach one end of it
to your wrist and the other end to any convenient electrical ground (for example, the
bare metal chassis of equipment, as on the back of a computer, that is plugged in but 
turned off). Never attach the wrist strap to any piece of equipment with an electrical
current present. Turn off all power switches first. Plastic, rubber, wood, painted metal
surfaces, and telephones are not acceptable grounding points. The printer isn't an
acceptable grounding point either because it must be unplugged before you perform
this task.
If you don't have an antistatic wrist strap, discharge your body's static electric
charge by touching a grounded surface before you handle any printer boards or
components and before removing the controller board. Also avoid walking around after
grounding yourself.
Single in-line memory modules (or SIMMs) are compact circuit boards with sur-
face-mount memory chips.
Your QMS magicolor 2+ Print System comes with the following printer memory:

QMS magicolor 2+ CXE Print System—32 MB RAM

QMS magicolor 2+ GXE Print System—80 MB RAM

QMS magicolor 2+ EXD Print System—192 MB RAM


Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Magicolor 2 plus and is the answer not in the manual?

Table of Contents