QMS Magicolor 2 plus Manual page 16

Print system

Hide thumbs Also See for Magicolor 2 plus:

Table of Contents

Remove the printer's controller board.

Loosen two screws, one on each end of the I/O connector panel, and, using the

tab on the lower side of the connector panel, pull the controller board from the

printer.

Note: The illustration shows the printer without the duplexer. However, the

instructions are the same for all models.

Position the controller board on a flat surface so the controller board lies flat

and the I/O connector panel is facing you.

If you need to remove a SIMM before installing one, remove it as follows;

otherwise skip to step 6.

Note: If all the SIMM connectors are filled and you want to install more memory,

you have to exchange one or more SIMMs for SIMMs with a greater memory

capacity.

Using both thumbs, pull the latches (one on each side of the SIMM connector)

outward.

Tilt the SIMM backwards to a 45° angle away from the SIMM connector.

Table of Contents

Chapters

Table of Contents

Do you have a question about the Magicolor 2 plus and is the answer not in the manual?