Replacing The Oven Light Bulb; Replacing The Door Seal - Siemens HB86P275B Instruction Manual

Problem
The microwave does not switch
on.
The appliance does not heat up to
the temperature which has been
set.
Microwave operation has been
cancelled for no apparent reason.
With microwave operation, the
food takes longer to heat up than
before.
Error messages with E
If an error message with E is shown in the display, press the
button. Then reset the clock. This cancels the error message. If
the error is shown again, call the after-sales service. With error
message E106, you can still operate the microwave.
If error message E011 is displayed, a button may have become
stuck. Press each button individually and check that they are all
clean. If the error message remains, please contact the after-
sales service.

Replacing the oven light bulb

It is possible to replace the oven light. Heat-resistant 12 V,
20 W halogen bulbs can be obtained from After-sales Service
or a specialist retailer.
ã=
Risk of electric shock!
Never replace the oven light when the appliance is switched on.
Pull out the mains plug or switch off the appliance at the circuit
breaker in the fuse box.
Note: Always remove the new halogen bulb from the packaging
using a dry cloth. This increases the service life of the bulb.
Method
Switch off the circuit breaker in the fuse box.
1.
Place a tea towel in the cold oven to prevent damage.
2.
Remove the glass cover. To do so, prise open the glass
3.
cover at the bottom by hand.
Should you experience difficulties removing the glass cover,
use a spoon to help. (Fig. A)
Remove the bulb and replace with a bulb of the same type.
4.
(Fig. B)
$
Possible cause
Door not fully closed.
The microwave was not started.
The † button was not pressed.
The microwave has a fault.
The microwave power setting is too low.
A larger amount than usual has been placed in
the appliance.
The food was colder than usual.
%
Remedy/information
Check whether food remains or foreign mate-
rial is trapped in the door. Make sure that the
sealing surfaces are clean. Check whether the
door seal is twisted.
Press the
Press the
If this fault occurs repeatedly, please call the
after-sales service. Oven operation without
microwave is possible.
Select a higher power setting.
Double the amount = almost double the time
Stir or turn the food during cooking
Refit the glass cover. (Fig. C)
5.
0
&
Remove the tea towel. Switch the circuit breaker in the fuse
6.
box back on or plug in the mains plug.

Replacing the door seal

If the door seal is defective, it must be replaced. Replacement
seals for your appliance can be obtained from the after-sales
service. Please supply your appliance's E number and FD
number.
ã=
Risk of serious damage to health.!
Never use the appliance if the door seal is damaged.
Microwave energy may escape. Do not use the appliance again
until it has been repaired.
Open the oven door.
1.
Remove the old door seal.
2.
There are 5 hooks attached to the door seal. Use these
3.
hooks to attach the new seal to the oven door.
Note: The presence of the join at the bottom of the door seal in
the centre is technically required.
† button.
† button.
19