Malfunction Table - Siemens HB86P275B Instruction Manual

Insert the door panel into the guide with both hands. (Fig. D).
4.
Push the door panel downwards, lift it slightly and hook it in
5.
at the top. (Fig. E).
'
Make sure that the door panel is sitting flush with the control
panel.

Malfunction table

Malfunctions often have simple explanations. Please refer to the
malfunction table before calling the after-sales service.
If a meal does not turn out exactly as you wanted, refer to the
Tested for you in our cooking studio section, where you will
find plenty of cooking tips and tricks.
Malfunction table
Problem
The appliance does not work.
"Set clock" appears in the status
bar. The time displayed is not the
current time. "Select language"
appears in the settings area on the
right.
The oven door cannot be opened.
"Set clock" appears in the status
bar. The time displayed is not the
current time. "Select language"
appears in the settings area on the
right. The H symbol is displayed.
The oven does not heat up.
"Demo" is displayed in the status
bar.
The oven does not heat up or the
type of heating selected cannot be
set.
"Automatic switch-off" appears in
the status bar.
18
(
Possible cause
Defective fuse
Plug not plugged in
Power cut
Power cut
Power cut during self-cleaning operation
The oven is in demo mode
Type of heating not recognised.
Automatic switch-off has been activated. The
oven switches off.
Fully open the door, while holding the panels firmly with one
6.
hand. (Fig. F).
Push the door downwards again and tighten the screws
7.
hand-tight using a flat-bladed screwdriver (blade width 8-
11 mm), close the door. (Fig. G).
)
Note: The oven may only be used again when the panels are
correctly installed.
ã=
Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be carried
out by one of our trained after-sales engineers.
Remedy/information
Look in the fuse box and check that the circuit
breaker is in working order.
Plug it in.
Check whether the kitchen light works.
Turn the rotary selector to set the correct time
then press the
remains unchanged following a power cut.
Turn the rotary selector to set the correct time
then press the
remains unchanged following a power cut.
Wait until the cooking compartment has
cooled down. The
can open the oven door again.
Switch off the circuit breaker in the fuse box
and then switch back on after approx.
20 seconds. Within the next 2 minutes, press
and hold the
"Demo" disappears from the status bar.
Set once again.
Press any button. The text disappears. You
can make settings again.
*
button. The language set
0
button. The language set
0
symbol goes out. You
H
@ button for four seconds until