Card Installation - Bosch Rexroth VT-VRPD-2 Installation & Operation Manual

12/32 Bosch Rexroth AG | Hydraulics
2 Installing the VRPD
2.4

Card Installation

Remove the card from its packaging only at a protected work place.
Do not touch any electrical components when placing the controller card in its proper
card holder as shown in Fig. 2.
Correctly installing the VRPD controller card:
Remove power from the rack when installing the card.
Hold the card by the front panel and remove it from the packaging.
Slide the card into the guide rails of the rack without using excessive force, as
shown in Fig. 2 Installing the controller card.
Snap the edge connector in place by gently pressing on the front panel.
male connector
mounting
screws
Faceplate
Fig. 2 Installing the controller card
Tighten the two mounting screws on the front panel.
The card is now installed correctly.
Installation and Operation | RE 30126-B/09.13
card
guide rails
HACD_HW_EN_2-2