Parts Supplied; Materials You Will Need; Tools You Will Need; Installation Preparation - GE Profile PDW8100 Series Installation Instructions Manual

PARTS SUPPLIED:

Two #8 Phillips flat head wood screws, 5/8" long to
secure dishwasher to underside of countertop or
sides of cabinetry. (Taped to top or side of dishwasher.)
Side and top trim pieces
Trim Panel Accessory Kit (not shown).
Model PDW9700 only
Drain Hose and Hose Clamp

MATERIALS YOU WILL NEED :

Ferrule, compression nut and 90 Elbow (3/8"NPT external
thread on one end, opposite end sized to fit water supply)
Thread seal tape
UL Listed wire nuts (3)
Materials For New Installations Only:
Air gap for drain hose, if required
Waste tee for house plumbing, if applicable
Electrical cable or power cord, if applicable
Screw type hose clamps
Strain relief for electrical connection.
Hand shut-off valve
Water line 3/8" min. copper
Coupler for extending drain line, if applicable

TOOLS YOU WILL NEED:

Phillips head screwdriver
5/16" and 1/4" nutdriver
6" Adjustable wrench
Level
Carpenters square
Measuring tape
Safety glasses
Flashlight
Bucket to catch water when flushing the line
15/16" socket (optional for skid removal)
Gloves
For New Installations Only:
Tubing cutter
Drill and appropriate bits
Hole saw set

Installation Preparation

Waste Tee
Phillips
Head
Screwdriver
15/16" Socket
Flashlight
Bucket
Gloves
2 Wood Screws
Drain Hose
Hand
Shut-Off
90 Elbow,
Valve
Ferrule and
Compression Nut
Electrical Cable
(or Power Cord, if applicable)
Screw Type
Hose Clamps
Air Gap
1/4"
and 5/16"
Nutdriver
6" Adjustable
Wrench
Safety Glasses
Hole Saw Set
2
Trim Pieces
(some models)
Hose Clamp
Wire Nuts (3)
Thread
Seal Tape
Hot Water line
Strain Relief
Level
Carpenters
Square
Tubing Cutter
Measuring Tape
Drill and Bits
Coupler