Step 2 Remove Wood Base, Install Leveling Legs; Step 3 Remove Toekick; Step 5 Install 90 Elbow; Step 4 Install Power Cord - GE Profile PDW8100 Series Installation Instructions Manual

STEP 2 REMOVE WOOD BASE,
INSTALL LEVELING LEGS
IMPORTANT
wood base! Damage will occur.
• Move the dishwasher close to the installation
location and lay it on its back.
• Remove the four leveling legs on the underside of
the wood base with an adjustable
wrench or 15/16" socket.
• Discard base.
Figure J
• Screw leveling legs back into the dishwasher
frame, approximately 1/4" from frame as shown.

STEP 3 REMOVE TOEKICK

• Remove the two toekick screws.
Figure K
Installation Instructions
–
Do not kick off
Approx.
3/4"
Remove 2
Toekick Screws

STEP 4 INSTALL POWER CORD

Skip this step if dishwasher will be direct wired or
has a factory installed power cord.
The power cord and connections must comply with
the National Electrical Code, Section 422 and/or local
codes and ordinances.
• Maximum power cord length is 6 feet.
A
Insert Power
Remove
Cord Wires Thru
Junction Box
Strain Relief
Cover
and Tighten
C Check That White, Black and
Green Dishwasher Wires Are Threaded
Thru Small Hole in Bracket
Figure L
• Connect incoming power cord white (or ribbed) to
dishwasher white, black (or smooth) to black and
ground to dishwasher green wire. Use UL listed
wire nuts of appropriate size.
• Replace junction box cover. Be sure wires are not
pinched under the cover.

STEP 5 INSTALL 90 ELBOW

• Wrap 90 elbow with thread seal tape.
• Install a 90 elbow onto the water valve.
90
Elbow
Figure M
• Do not over tighten 90 elbow, water valve bracket
could bend or water valve fitting could break.
• Position the end of the elbow to face the rear of the
dishwasher.
6
B
White
Ground
D
Use UL Listed
Wire Nuts
Front of Dishwasher
Water Valve
Bracket
Fill
Hose
Thread
Seal Tape
Black