Parts Supplied; Materials You Will Need; Tools You Will Need; Installation Preparation - GE Built-In Dishwasher Installation Instructions Manual

PARTS SUPPLIED:

Two #8 Phillips flat head wood screws, 5/8" long to
secure dishwasher to underside of countertop or to
side of cabinetry. (Taped to top or side of
dishwasher.)
Side and top trim pieces
2 Side mounting brackets with 4 mounting screws
(for non-wood countertops) on some models

MATERIALS YOU WILL NEED :

Ferrule, compression nut and 90° Elbow (3/8"NPT external
thread on one end, opposite end sized to fit water supply)
Thread seal tape
UL Listed wire nuts (3)
Materials For New Installations Only:
Air gap for drain hose, if required
Waste tee for house plumbing, if applicable
Electrical cable or power cord, if applicable
Screw type hose clamps
Strain relief for electrical connection.
Hand shut-off valve (recommended)
Water line 3/8" min. copper or 1/2" min. plastic
(plastic must be tested for temperature and pressure)
Coupler for extending drain line, if applicable

TOOLS YOU WILL NEED:

Phillips head screwdriver
5/16" and 1/4" nutdriver
6" Adjustable wrench
Level
Carpenters square
Measuring tape
Safety glasses
Flashlight
Bucket to catch water when flushing the line
15/16" socket (optional for skid removal)
Gloves
For New Installations Only:
Tubing cutter
Drill and appropriate bits
Hole saw set

Installation Preparation

2 Wood Screws 4, #8 Pan head Phillips Screws
Phillips
Head
Screwdriver
15/16" Socket
Flashlight
Gloves
Bucket
Trim Pieces
(some models)
3/8" long for side mounting
(some models)
Hand
Shut-Off
90° Elbow,
Valve
Ferrule and
Compression Nut
Electrical Cable
(or Power Cord, if applicable)
Waste Tee
Screw Type
Air Gap
Hose Clamps
1/4"
and 5/16"
Nutdriver
6" Adjustable
Wrench
Safety Glasses
Hole Saw Set
2
Side Mounting Brackets
(some models)
Wire Nuts (3)
Thread
Seal Tape
Hot Water line
Strain Relief
Level
Carpenters
Square
Tubing Cutter
Measuring Tape
Drill and Bits
Coupler