GE Profile CDW9000 Series Owner's Manual

Hide thumbs

Safety Instructions
Care and Cleaning ................
Loading the Racks .............
Tips ..... 16-18
Consumer Support
19, 20
Write the model and serial
Model #
Serial #
You can find them on the tub wall
just inside the dooE
06-07 JR



  Related Manuals for GE Profile CDW9000 Series

  Summary of Contents for GE Profile CDW9000 Series

  • Page 1: Table Of Contents

    Safety Instructions ..Operating Instructions CDWgO00 Series Care and Cleaning ....oL__ PDW8000 Series Control Panel and Settings ..PDWgO00 Series Flashing Displag Lights ....Loading Place Settings .... Loading the Racks ..... 12-14 Using the Dishwasher ... 8-11 Troubleshooting Tips ..
  • Page 2 If you did not receive on Installation Instructions sheet with gout dishwasher, you can receive one bg visiting our website at • Connect to a grounded metal, permanent wiring • Do not attempt to repair or replace any part system;...
  • Page 3 Cascade Crustal Clear_ rinse agents have been • Do not allow children to plag around dishwasher approved for use in a(I GE dishwashers, when opening or closing door due to the possibilitg • Do not mix any chlorine bleach-based...
  • Page 4: Control Panel And Settings

    About the dishwasher control panel. You canlocate yourmodelnumberonthetubwalljust insidethedoor.Throughout thismanual, f eatures and appearance m ay varyfromyour model. PDW8100 Series-PDW8900 Series PDW9200 Series-PDW9900 Series and CDW9000 Series ENHANCEMENTS Control Settings Status Indicator Lights (Indicatorsvary by models) TheStatus displagtells gou what is happening while the dishwasheris in operation and mag flash, indicating a malfunction.
  • Page 5 Selections (continued) ANTFBACTERIAHeavg &8 gaL 105 rain. Medium 7,5gaL 95 min, Ught 6.3gaL 85 rain. Thiscgcle raisesthe water temperature in the final rinseto sanitize gout dishware.The cgcle length will varg depending on the temperature of gout inlet water. NOTE: T he Anti-Bacteria cycle is monitored for sanitization requirements,ff the cgcle is...
  • Page 6 About the dishwasher control panel. _.l_ Enhancements The light above the selected pad will be ON to indicate which ENHANCEMENThas been selected. DELAYHOURS You can delay the start of a wash cgcle for up to 24 hours (depending on model). Press the DELAYSTART pad to choose the number of hours you want to delay the start of the cycle;...
  • Page 7: Flashing Displag Lights

    Start (continued) PDW9000 Series After selecting the cycle and desired enhancements, touch the START/RESET p ad to ready the dishwasher to begin the cycle. Closethe door to start the cycle or begin the DELAYSTART countdown. When the cycle starts, the water fill begins and approximately 60 seconds later the wash action begins.
  • Page 8: Using The Dishwasher

    Using the dishwasher. Check the Water Temperature The entering water should be at least 120°F and not more than 150°F for effective cleaning and to prevent dish damage. Check the water temperature with a candy or meat thermometer. Turn on the hot water faucet nearest the dishwasher, place the thermometer in a gloss and let the water run continuously into the gloss until the temperature stops rising.
  • Page 9 Manual Detergent Dispenser Yourdishwasher c omesequippedwith an automaticliquid Forheavilysoiledloads,usea bit moredetergent.Forwater dishwasher d etergentdispenser (SmartDispense and a temperatures above140°F, usea bitlessdetergent. manualdispenserYoucan useeitherof thesedispensers but don'tusebothat the sametime. Hedium Hedium Extremely Soft Soft Hard Hard SmartDispense mn MAIN WASH...
  • Page 10 To utilize the SmartDispense Detergent Dispenser, it must first be filled. Although ang liquid or ge! automatic dishwashing detergent cart be used in the SmartDispense sgstem, all liquid or gel automatic dishwashing detergents are not the same.
  • Page 11 SmartDispense :MDetergent Dispenser Water Hardness Calibration Prior to the first use, the dishwasher needs to r-31 Pressthe "Up" _ Arrow Pad to raisethe value be calibrated for water hardness. Pleasefollow or the "Down" _ Arrow Pad to lower the value.
  • Page 12: Loading The Racks

    Loading the dishwasher racks. For best dishwoshing results, follow these loading guidelines. Features and appearance of racks and silverware baskets may vary from gout model. Upper Rack Although the upper rack is primarily for Secure larger dishwasher-safe plastics over glasses,cups and saucers, pots and pans can 2 tines when possible.
  • Page 13 Lower Rock The lower rack is best used for plates, saucers Also, be careful not to let a portion of an item and cookware, Large items such as broiler such as a pot or dish handle extend through the bottom rack. This could block the wash pans and baking racks should go along the left-hand side.
  • Page 14: Loading Place Settings

    Loading the dishwasher racks. (onsomemodels) Extra Rack Features Cutlery Tray The cutlery trag holds up to 4 large knifes such as a carver, chef's knives, bread knife, etc., that are too tall to fit in the silverware basket. Hook the trag onto the rear of the upper rack. Lag the knives between the guides (as shown).
  • Page 15: Operating Instructions Care And Cleaning

    Inner Door The stainless steel used to make the dishwasher tub and inner door provides the highest reliability available in a GE dishwasher. If the dishwasher tub or inner door should be scratched or dented during normal use,they will not rust or corrode.
  • Page 16: Troubleshooting Tips

    Before you call for service... Save time and money! Review the charts on the following pages, or visit You may not need to call for service. Troubleshooting Tips Error Messages Possible Causes What To Do • PresstheSTART/RESETpadonluonetimetostartthedishwasher.Whenthe START/RESET s tatus...
  • Page 17 Problem Possible Causes What To Do Spots and filming Extremelyhard water • UseJet-Dry®orCascadeCrystalClear*'rinseagentstoremovespotsand on glassesand preventnewfilm buildup. Lowinlet water temperature flatware • Hakesurewatertemperatureisat least120°R Overloadingthe dishwasher • Loaddishwasher a sshownin the Loading PlaceSettings section. Improper loading • Hakesuredetergentisfresh. Old or damp powderdetergent •...
  • Page 18 Before you call for service... Troubleshooting Tips Problem Possible Causes What To Do Dishwasherwon't run Fuseis blownor circuit breaker • Replace fuse or resetcircuitbreaken Remove anu otherappliances from the circuit. is tripped Poweristurned off • Insome installations, the powerto the dishwasher i s providedthrougha wallswitch,often locatednextto the disposer switch.Hakesureit is on.
  • Page 19: Product Registration

    Plus there's no extra charge for emergency service and low monthlg financing is available. Even icemaker coverage and food spoilage protection is offered. You can rest easg knowing that all gour valuable household products are protected against expensive repairs. Place your confidence in GE and call us for more information in the U_S. 800.626.2224 888.261.2133...
  • Page 20 If gou did not get a registration card with gour product, detach and return the form below to ensure that gour product is registered, or register online at Canadian consumers, please use the mail-in card on page 19 in the French Language section. ._,,_...
  • Page 21 Notes.
  • Page 22 Notes.
  • Page 23: Warranty

    Customer Care ®technician. To schedule service, on-line, Proof of the original purchase 24 hours a dog, visit us at, or call 800.GE.CARES (800.432.2737) date is needed to obtain service in the United States. In Canada, call 1.800.561.3344. Please have under the warranty.
  • Page 24: Consumer Support

    Contact Us In the U.S.: If you are not satisfied with the service you receive from GE, contact us on our Website with all the details including your phone number, or write to: General Manager, Customer Relations GE Appliances, Appliance Park Louisville, KY 40225 In Canada:,...