Precautions; Installation Precautions; Prestart Precautions; Operating Precautions - Toshiba 1600XP SERIES Installation And Operation Manual

2.0

Precautions

2.1

Installation Precautions

1) Install the unit in a well ventilated location; allow at least 10 cm (4 inches) on
all sides for air ventilation and maintenance.
2) Install the unit in a stable, level, and upright position, which is free of vibration.
3) Install the unit where the ambient temperature is within the correct operating
range.
4) Do not install the Battery System in a location that is subject to high humidity.
5) Do not install the unit at sites that are exposed to direct sunlight.
6) Do not install the Battery System in areas which are subject to high levels of
contamination by airborne dust, metal particles, or flammable gases.
7) Avoid installation near sources of electrical noise. Always make sure that the
unit ground is intact to prevent electrical shock and to help reduce electrical
noise.
8) Do not install where water or any foreign objects/substances may get inside
the Battery System.
2.2

Prestart Precautions

1) Before connecting the Battery System to the UPS verify that the two are compatible by
comparing them to the following chart.
UPS Model Number
UH3G2L080C61T
UH3G2L100C61T
UH3G2L140C61T
UH3G2L180C61T
UH3G2L220C61T
WARNING
2) Before connecting the Battery System to the UPS; switch the ON/OFF switch MCCB2,
located on the rear panel of the battery system to the OFF position. (See Sections 4 &
5)
2.3

Operating Precautions

1) The UPS should not be powered up until the entire operation manual has been
reviewed.
6
Battery Cabinet Model Number
UH31-BC-1825
DO NOT attempt to connect if the Model numbers do
not match the above chart. This will result in damage
to the UPS, the Battery System, or both. Call your
Toshiba representative if you should have any
questions.
1600XP 8-22kVA Battery Cabinet Installation and Operation Manual
Battery Voltage
288VDC