Table of Contents
Advertisement
3.0
Precautions
3.1
Installation Precautions
1)
Install the unit in a well ventilated location; allow at least 10 cm (4 inches) on
all sides for air ventilation and for maintenance.
2)
Install the unit in a stable, level, and upright position which is free of vibration.
3)
Install the unit where the ambient temperature is within the correct operating
range.
4)
Do not install the Battery System in areas that are subject to high humidity.
5)
Do not allow direct sunlight to shine on the unit.
6)
Do not install the Battery System in areas which are subject to contamination
such as high levels of airborne dust, metal particles, or inflammable gas.
7)
Avoid installation near sources of electrical noise and always make sure that
the unit ground is intact to prevent electrical shock and to help reduce
electrical noise.
8)
Do not install where water or any foreign object/substances may get inside the
Battery System.
3.2
Prestart Precautions
1)
Before connecting the Battery System to the UPS verify that the two cabinets are
compatible by comparing them to the following chart.
WARNING
2)
Before connecting the Battery System to the UPS; move the (MCCB-C) switch
(ON/OFF), on the rear panel (See Sections 5 & 6), to the
3.3
Operating Precautions
1)
The Battery Cabinet should not be powered up until the entire operation manual
has been reviewed.
CAUTION
CAUTION
UPS Model Number
UC3G2L024C6(#)
UC3A2L024C6(#)
UC3G2L036C6(#)
UC3G2L060C6(#)
UC3G2L080C6(#)
DO NOT attempt to connect if the Model numbers do
not match the above chart. This will result in damage
to the UPS, the Battery System, or both. Call your
Toshiba representative if you should have any ques-
tions.
CAUTION
3 - 1
Battery Cabinet Model Number
UC3-BC-0230
UC3-BC-0260
UC3-BC-0330
UC3-BC-0360
UC3-BC-0630
UC3-BC-0660
UC3-BC-0830
OFF position.
TOSHIBA
Advertisement
Table of Contents
