Precautions; Installation Precautions; Prestart Precautions - Toshiba 1600EP Series Operation Manual

2.0 Precautions

2.1

Installation Precautions

1) Install the unit in a well ventilated location; allow at least 10 cm (4 inches) on
all sides for air ventilation and maintenance.
2) Install the unit in a stable, level, and upright position, which is free of vibration.
3) Install the unit where the ambient temperature is within the correct operating
range.
4) Do not install the Battery System in a location that is subject to high humidity.
5) Do not install the unit at sites that are exposed to direct sunlight
6) Do not install Battery System in areas which are subject to high levels of
contamination by airborne dust, metal particles, or flammable gases.
7) Avoid installation near sources of electrical noise. Always make sure that
the unit ground is intact to prevent electrical shock and to help reduce
electrical noise.
8) Do not install where water or any foreign objects/substances may get inside
the Battery System.
2.2

Prestart Precautions

1) Before connecting the Battery System to the UPS verify that the two are compatible
by comparing them to the following chart.
UPS Model Number
UE3G2L080C61T
UE3G2L100C61T
UE3G2L140C61T
UE3G2L180C61T
WARNING
2) Before connecting the Battery System to the UPS; move (MCCB2 of the battery
system) switch (ON/OFF), on the rear panel (See Sections 4 & 5), to the OFF
position.
TOSHIBA
Battery Cabinet Model Number
UE31-BC-1825
DO NOT attempt to connect if the Model numbers
do not match the above chart. This will result in
damage to the UPS, the Battery System, or both.
Call your Toshiba representative if you should have
any questions.
8
Battery Voltage
288VDC