Front Chassis Trim Replacement - Fisher & Paykel DishDrawer DD247 Service Manual

70

9.27 Front Chassis Trim Replacement

Bottom tub only - Remove the toe kick, refer section
1.
9.4, and the bottom cowling, refer section 9.5.
Remove the drawer front, refer section 9.2, handle
2.
refer section 9.3, and the tub, refer section 9.6.
Remove both the left hand and right hand yokes, refer
3.
section 9.20. This is to prevent damaging the locating
tab at the front of each yoke where it slides up into the
rear of the chassis trim.
Remove the trim by releasing the trim clips with long
4.
nose pliers, and pull trim forward to release from the
chassis.
Refit in reverse manner.
5.
9.28 Single Integrated Vent Duct Removal
(Some models only)
Remove the drawer front, refer section 9.2.
1.
Pull the drawer front slightly forward and remove the
2.
T10 torx screw retaining the duct.
Slide the duct from the right hand side off the tub.
3.
Refit in reverse manner.
4.
Trim Clips
T10 Torx Screw
Slide Off Tub
D
D