Wall Control Procedures - Emerson CF550ORB00 Owner's Manual

Luxe eco 54” ceiling fan

Hide thumbs Also See for CF550ORB00:

Owner's manual (17 pages)

Table Of Contents

Table of Contents

General

Your Emerson Ceiling Fan/Light Control consists of

wall mounted transmitter and a receiver which is pre-

installed inside the motor assembly. The remote

control is designed to separately control your ceiling

fan speed and light intensity.

Code switches in the transmitter and receiver may be

set in 32 different positions. If your fan and light go on

and off without using your control, you may be getting

interference from other remote units such as garage

door openers, car alarms or security systems. To

remedy this situations, simply change the code switch

combination in your transmitter.

Setting Operating Frequency of Wall Control

Your wall control has code switches which must be

set in one of 32 possible code combinations (Figure

15). The five levers (numbered 1, 2, 3, 4, and 5) on

the switches are factory-set in the ON (up) position.

Change the switch settings as follows:

1. Slide the five switch levers in the wall control to

your choice of ON (up) or down positions. Use a

ball-point pen or small screwdriver and slide the

levers firmly up or down.

2. The sixth switch marked ON and I is for dimming

control of lights: Set switch to ON to allow for

dimming of the lights. Set switch to I for no

dimming of the lights such as for fluorescent bulbs.

Wall Control Installation

SINGLE-POLE INSTALLATION

WARNING

Turning off wall switch is not sufficient. To avoid

possible electrical shock, be sure electricity is

turned off at the main fuse or circuit breaker box

before wiring. All wiring must be in accordance with

National and Local codes and the ceiling fan must be

properly grounded as a precaution against possible

electrical shock.

CAUTION: To reduce the risk of electrical shock,

disconnect the electrical supply circuit before

installing the fan, light kit or receiver.