Wall Control Procedures - Emerson CF5200BS00 Owner's Manual

BP7511-1 CF5200 Penbrooke Select Eco.qxp_ BP7511 2/8/16 12:02 PM Page 17
7.1
Your Emerson Ceiling Fan/Light Control consists of wall
mounted transmitter and a receiver which is mounted
under the fan ceiling cover. The remote control is
designed to separately control your ceiling fan speed and
light intensity.
7.2
Your wall control has code switches which must be set in
one of 32 possible code combinations (Figure 25). The
five levers (numbered 1, 2, 3, 4, and 5) on the switches
are factory-set in the ON (up) position. Change the switch
NOTE: Do not duplicate the code of an existing settings as follows:
control of an installed ceiling fan within 100 feet.
7.3
Slide the five switch levers in the wall control to your
choice of ON (up) or down positions. Use a ball-point pen
7.4
or small screwdriver and slide the levers firmly up or down.
The sixth switch marked ON and I is for dimming control of
lights: Set switch to ON to allow for dimming of the lights.
Set switch to I for no dimming of the lights such as for
7.5
fluorescent bulbs and non-dimming CFLs.
Preset Memory Feature: Your Emerson receiver is
equipped with a preset memory feature. If the AC supply
to the receiver is powered through a wall switch, when the
switch is turned OFF, the control will remember the light
intensity and fan speed. When the switch is turned back
ON the light and fan will resume operation as they were
prior to the switch being turned OFF.

7. Wall Control Procedures

17
Code switches in the transmitter and receiver may be set
in 32 different positions. If your fan and light go on and off
without using your control, you may be getting interference
from other remote units such as garage door openers, car
alarms or security systems. To remedy this situations,
simply change the combination code in your transmitter
and receiver.
WALL CONTROL
CODE SWITCHES
1
Figure 25
ON
2 3 4 5 I
CODE
SWITCHES
WALL
CONTROL