Maintenance - Emerson CF550ORB00 Owner's Manual

Wall Control Installation
WARNING
!
Check to see that all connections are tight and that
no bare wires are visible at the wire connectors.
6. Screw wall control into wall box using the supplied
screws. Leave wall control in "OFF" mode until
fan installation is completed.
7. The wall control is supplied with a white, ivory, and
almond color switch covers. Choose the finish that
best suits your needs and snap the cover onto the
wall control (Figure 17).
8. Next, install the other wall control into the wall box
containing the load wire. Connect the black wire of
the wall control to the traveler wire(s) already
connected to the black wire (in the other wall box).
Secure with wire connectors supplied.
9. Connect one black wire of the wall control to the
"load" (black) wire and secure with wire connector
supplied.
10. Restore electricity to your ceiling fan from the main
fuse box or breaker panel.
3-WAY WIRING DIAGRAM:
NEW CONSTRUCTION
SW605
HOT
HI FAN/LIGHT
LIGHT
MED
LOW
WALL
FAN OFF
®
EMERSON
OFF ON CONTROL
BLACK
TRAVELER
WIRE
NEUTRAL
RECEIVER LOCATED
ON TOP OF THE
CEILING FAN
Figure 18
IMPORTANT CARE INSTRUCTIONS
for your Ceiling Fan
Periodic cleaning of your new ceiling fan is the only
maintenance that is needed.
When cleaning, use only a soft brush or lint free cloth
to avoid scratching the finish.
Abrasive cleaning agents are not required and should
be avoided to prevent damage to finish.
HI
LIGHT
MED
LOW
FAN OFF
EMERSON ®
OFF ON
LOAD
BLACK
GROUND

Maintenance

11
(continued)
STANDARD WIRING FOR EXISTING
3-WAY CONTROLS
WALL CONTROL
HOT
BLK
TRAVELER WIRES
3-WAY WIRING DIAGRAM: RETROFIT
BLK
HOT BLK
HI
LIGHT
MED
LOW
FAN OFF
EMERSON ®
OFF ON
FAN/LIGHT
WALL CONTROL
TRAVELER WIRES
Figure 19
WARNING
!
Do not use water when cleaning your ceiling fan. It
could damage the motor or the blades and create the
possibility of an electrical shock.
EXISTING
LOAD
BLK
BLK
HI
LIGHT
MED
LOW
FAN OFF
EMERSON ®
OFF ON
LOAD
ETL Model No.: CF550