Wall Control Procedures - Emerson CF766LBQ00 Owner's Manual

7.1
Your Emerson Ceiling Fan/Light Control consists of a
wall mounted Transmitter and a Receiver located inside
the Ceiling Cover. The Control is designed to remotely
operate your Ceiling Fan Speed and Light Intensity.
7.2
Your Wall Control has Code Switches which must be
set in one of 32 possible Code Combinations
(Figure 30). The Five Levers (numbered 1, 2, 3, 4,
and 5) on the Switches are factory-set in the ON (up)
position. Change the Switch settings as follows:
NOTE: Do not duplicate the Code of an existing
Control of an installed Ceiling Fan within 100 feet.
7.3
Slide the Five Switch Levers in the Wall Control to your
choice of ON (up) or down positions. Use a ball-point
pen or small Screwdriver and slide the Levers firmly up
or down.
7.4
The Sixth Switch marked ON and I is for dimming
control of Lights: Set Switch to ON to allow for dimming
of the Lights. Set Switch to I for no dimming of the
Lights.
7.5
Preset Memory Feature: Your Emerson Ceiling
Fan/Light Control is equipped with a preset memory
feature. When the Electricity Supply to the Fan is
switched OFF, the Control will remember the Light
Intensity and Fan Speed. When the Switch is turned
back ON, the Light and Fan will resume operation as
they were prior to the Switch being turned OFF.

7. Wall Control Procedures

Code Switches in the Transmitter may be set in
32 different positions. If your Fan and Light turn on and
off without using your Control, you may be getting
interference from other remote units such as garage
door openers, car alarms or security systems.
To remedy this situations, simply change the Code
Switches in your transmitter per the instructions of
Section 7.2.
Figure 30
18
WALL CONTROL
CODE SWITCHES
ON
1 2 3 4 5
I
CODE
SWITCHES
WALL
CONTROL
ETL Model No.: CF766L