Using Your Ceiling Fan - Emerson CF550ORB00 Owner's Manual

Programming the Receiver Operating Frequency &
High Speed Conditioning of Fan Control
IMPORTANT: Ceiling fan blades MUST be
installed before high speed conditioning
can begin.
1. Within 1 minute of restoring electricity to the
ceiling fan, push and hold the fan OFF button (
for 3 to 5 seconds to set the code in the receiver.
The ceiling fan lights (if installed) will blink to
indicate the transmitted has been paired with the
receiver.
IMPORTANT: Immediately after successful
pairing, the ceiling fan will automatically
begin high speed conditioning of the
motor. During conditioning, the electronic
motor control software is calculating
speeds for the 2nd through 5th speed
settings based on the blades that were
installed on the fan.
2. The fan will run for approximately 2 minutes in the
upward direction then reverse direction to down
flow and run an additional 2 minutes. When
conditioning is complete, the fan will come to
complete stop.
WARNING
!
Fan installation must be completed, including the
installation of the fan blades, before testing the remote
control.
Your wall control has full control of your fan and light.
1.To set the desired fan speed, press the (
to decrease the speed and the (
speed. The LED display will light up to indicate the
new speed selected.
2.To turn the light on and off, press and release the
LIGHT ( ) button. To set the light intensity, press
and hold the LIGHT (
on at the light intensity previously selected.
3.Your wall control comes complete with your choice
of three wall cover plates; ivory, white and light
almond.
4. If airflow is desired in the opposite direction, press
the ( ) button on the wall control. The fan must
be operating at any speed for the reverse button to
function. The blades will turn in the opposite
direction and reverse the airflow.

Using Your Ceiling Fan

) button
) to increase the
) button. The light will turn
IMPORTANT: Do not interrupt the
conditioning until the fan comes to a
complete stop in approximately 5 minutes.
All functions of the control will be rejected
) during conditioning.
3. High speed conditioning is now complete.
4. If programming is unsuccessful, retry the above
instructions after cycling the wall control ON/OFF
switch to restart the 1 minute programming time
period.
5. If still unsuccessful, shut off the electricity at the
fuse box or breaker panel and change the wall
control frequency (page 9). After changing the
frequency settings, repeat instruction #1 of this
section within one minute of restoring the
electricity.
POWER
INDICATOR
LIGHT
FAN
DIRECTION
FAN
BUTTON
Figure 20
12
LIGHT
BUTTON
HIGH TO LOW
SPEED BUTTONS
ON/OFF SWITCH
O = OFF / — = ON
ETL Model No.: CF550