Your Ceiling Fan - Emerson TILO CF130WW00 Owner's Manual

BP7404 Tilo 12/16/09
How to Hang Your
Ceiling Fan For
Standard Mounting
1. Carefully lift the fan assembly and seat
the hanger ball in the hanger bracket
(Figure 15). The tab on the hanger
bracket must seat in the groove in the
hanger ball.
WARNING
!
Failure to seat tab in groove could cause
damage to electrical wires and possible
shock or fire hazard.
WARNING
!
To avoid possible fire or shock, do not pinch
wires between the hanger ball/downrod
assembly and hanger bracket.
TAB
GROOVE
Figure 15
How to Wire

Your Ceiling Fan

If you feel that you do not have enough
electrical wiring knowledge or experience,
have your fan installed by a licensed
electrician.
WARNING
!
Turning off wall switch is not sufficient.
To avoid possible electrical shock, be
sure electricity is turned off at the main
fuse box before wiring. All wiring must be
in accordance with National and Local
codes and the ceiling fan must be
properly grounded as a precaution
against possible electrical shock.
4:06 PM Page 10
NOTE: Make all wiring connections
using wire connectors (supplied). Make
sure that all connections are tight,
including ground, and that no bare wire
is visible at the wire connectors, except
for the ground wire.
1. Connect the green grounding lead from
the
grounding lead from the hanger bracket
to the grounding conductor of supply
(this may be a bare wire or wire with
green colored insulation) (Figure 16).
Securely connect wires using wire
connectors supplied.
NOTE: When wiring the ceiling fan for
close-to-the-ceiling mounting, there
will be no green grounding lead from
the hanger ball.
2. Securely connect the fan motor white
wire to the supply white (neutral) wire
using wire connector supplied (Figure
16). Securely connect the fan motor
black wire and blue wire to the supply
black (hot) wire using wire connector
supplied (Figure 16). After connections
have been made, turn leads upward
and carefully push leads into the outlet
box, with the white and green leads on
one side of the outlet box and the black
HANGER
and blue leads on the other side of the
BRACKET
outlet box.
HANGER
BALL
BLUE
FAN WIRE
BLACK
FAN WIRE
WHITE SUPPLY
NEUTRAL)
WHITE FAN WIRE
Figure 16
Check to see that all connections are
tight, including ground, and that no bare
wire is visible at the wire connectors,
except for the ground wire. Do not
operate fan until blades are in place.
Noise and fan damage could result.
10
hanger ball and the
WIRE CONNECTOR
BLACK
SUPPLY (HOT)
GREEN
GROUND WIRE
FROM HANGER
BRACKET
GREEN
GROUND
WIRE FROM
HANGER BALL
WARNING
!
UL Model No.: CF130
green
SUPPLY
GROUND
WIRE