Electrical Requirements; Ceiling Fan - Emerson TILO CF130WW00 Owner's Manual

BP7404 Tilo 12/16/09

Electrical Requirements

Your new ceiling fan will require a
grounded electrical supply line of 120 volts
AC, 60 Hz, 15 amp circuit.
The outlet box must be securely anchored
and capable of withstanding a load of at
least 50 pounds.
WARNING
!
To reduce the risk of fire, electric shock,
or personal injury, mount fan to outlet box
marked "Acceptable for Fan Support",
and use screws supplied with outlet box.
Most outlet boxes commonly used for
support of light
acceptable for fan support and may need
to be replaced. Consult a qualified
electrician if in doubt.
If your fan is to replace an existing ceiling
light fixture, turn electricity off at the main
fuse or circuit breaker box at this time and
remove the existing light fixture.
WARNING
!
Turning off wall switch is not sufficient.
To avoid possible electrical shock, be
sure electricity is turned off at the main
fuse or circuit breaker box before wiring.
All wiring must be in accordance with
National and Local codes and the ceiling
fan must be properly grounded as a
precaution against possible electrical
shock.
How to Assemble Your

Ceiling Fan

1. Position the fan motor assembly upside
down in preparation for mounting the
three fan blades.
2. Rotate the notched switch assembly to
expose the holes for blade assembly
(Figure 1).
3. Slide blade through blade slot in blade
housing assembly. Mount blade to fan
housing using two M5 x 14mm flange
head blade screws (Figure 1).
4:06 PM Page 5
NOTE: Take care not to scratch fan
housing assembly when installing
blades.
FAN
HOUSING
SLIDE FAN BLADE
INTO BLADE
CENTER SLOT
Figure 1
fixtures are not
4. Complete the remaining two blades
installation per the above instructions.
5. Remove the three M4 x 8mm flat head
screws from the switch housing
adapter plate (Figure 2). Retain the
screws for future installation.
6. Engage the connector of the switch
housing assembly with the motor
connector
connectors are keyed and color-coded
and must be mated correctly (color-to-
color) before they can be engaged.
Make sure the connector latch closes
properly.
Figure 2
5
M5 x 14mm FLANGE HEAD
BLADE SCREWS (2 per blade)
NOTCHED SWITCH ASSEMBLY
FAN BLADE SLOT
FAN BLADE
(Figure 2). The
SWITCH HOUSING
COVER
SWITCH HOUSING
CONNECTOR
MOTOR
CONNECTOR
REMOVE M4 x 8mm
FLAT HEAD SCREWS (3)
UL Model No.: CF130
two