Page 1
Brushed Steel CF110ORB00 - Oil Rubbed Bronze 23.7 Net Weight: Lbs. Questions, problems, missing parts: Before returning to the store call Emerson Electric Customer Service 8 a.m. - 6 p.m., EST, Monday-Friday 1-800-654-3545 Part No. F40BP74660000 Form No. BP7466 www.emersonfans.com 11/12...
Emerson could result in personal injury or property damage. 2. All wiring must be in accordance with the National Electrical Code “ANSI/NFPA 70-2011”...
Emerson Electric Co. Substitution of parts or Hanger Ball/Downrod Assembly accessories not designated for use with this product by Emerson Electric Co. could result in personal injury Upper Glass Retainer or property damage. Glass Shade 1.
This Manual Is Designed to Make it as Easy as Possible for You to Assemble, Install, Operate and Maintain Your Ceiling Fan Installed Wire Length Wire Size A.W.G. Tools Needed for Assembly Up to 50 ft. One Phillips head screwdriver One stepladder 50-100 ft.
Page 5
NOTE: Take care not to scratch fan housing when FLANGE/BLADE ASSEMBLY installing blades. 1/4-20 x 1/2" FLANGE SCREWS WITH LOCKWASHERS PRE-ASSEMBLED (2) MOTOR HUB 4. Attach the flange/blade assembly to the motor hub using the two pre-installed 1/4-20 x 1/2” flange screws and lockwashers.
Page 6
9. Remove the hanger ball by loosening the setscrew in the hanger ball until the ball falls freely down the HANGER BALL downrod (Figure 8). Remove the pin from the downrod, then remove the hanger ball. Retain the pin and hanger ball for reinstallation in Step 14. SETSCREW DOWNROD 10.
14. Reinstall the hanger ball (Figure 12) on the downrod as follows. Route the three 80” motor leads through HANGER BALL the hanger ball. Position the pin through the two holes in the downrod and align the hanger ball so CEILING DOWNROD the pin is captured in the groove in the top of the...
How to Hang Your Ceiling Fan WARNING CEILING Turning off wall switch is not sufficient. To avoid possible electrical shock, be sure electricity is turned off at the main fuse box before wiring. All wiring must be in accordance with National and Local codes and the ceiling fan must be properly grounded as a precaution against possible electrical shock.
CEILING COVER Emerson Electric Co. Substitution of parts or accessories not designated for use with this product by Emerson Electric Co. could result in personal injury LOCKWASHERS (2) or property damage. THREADED STUD (2) 2. Securely connect the fan motor white wire to the...
Wall Control Installation WARNING Turning off wall switch is not sufficient. To avoid possible electrical shock, be sure electricity is turned off at the main fuse box before wiring. All wiring must be in accordance with National and Local codes and the ceiling fan must be properly grounded as a precaution against possible electrical shock.
To avoid accidental pull chain use, shorten chain by cutting it 1” below switch body. The SW46 speed control turns all Emerson Ceiling Fans into four-speed fans. Using Your Ceiling Fan 1. Restore electrical power to the outlet box by turning the electricity on at the main fuse box.
The use of any other control not specifically approved accessories not designated for use with this product for this fan could result in fire, shock and personal by Emerson Electric Co. could result in personal injury injury. or property damage.
Page 15
What We Will Do To Correct Problems: If during the one (1) year warranty period the motor or any component or accessory of your Emerson Ceiling Fan is defective in materials or workmanship, or if during the expected lifetime of the Emerson Ceiling Fan (when used in accordance with the User Manual or other instructions) the motor is defective in materials or workmanship, you must contact Emerson during the applicable warranty period.
Page 16
Air Comfort Products DIVISION OF EMERSON ELECTRIC CO. 8100 W. Florissant • St. Louis, MO 63136 Questions, problems, missing parts: Before returning to the store call Emerson Electric Customer Service 8 a.m. - 6 p.m., EST, Monday-Friday 1-800-654-3545 www.emersonfans.com Retain this manual for future use.