Technical Specifications - HP ProLiant DL2000 Specification

QuickSpecs

Technical Specifications

System Unit Dimensions (H x W x D)
(with bezel)
Weight
(approximate)
Input Requirements
(per power supply)
Power Specifications
Power Supply Output
(per power supply)
System Inlet
Temperature
Relative Humidity
(non-condensing)
Altitude
Acoustic Noise
DA - 13847 North America — Version 31 — December 13, 2013
HP ProLiant DL2000 Multi Node Server
3.44 x 17.64 x 28.91 in (8.74 x 44.81 x 73.43 cm)
Maximum
(all hard drives, power
supplies, and processors
installed)
Minimum
(one hard drive, power
supply, and processor
installed)
Rated Line Voltage
Rated Input Current
Rated Input Frequency
Rated Input Power
NOTE: To review typical system power ratings use the HP Power Advisor
which is available online located at url:
efficient or www.hp.com/go/hppoweradvisor
Rated Steady-State Power 653.10W (at 100 VAC),
Operating
Non-operating
Operating
Non-operating
Operating
Non-operating
Listed are the declared A-Weighted sound power levels (LWAd) and declared
77.00 lb (34.93 kg)
49.00 lb (22.22 kg)
90 to 140 VAC
180 to 264 VAC
7.31A at 115VAC
3.6A at 230VAC
47 to 63 Hz
855W (at 100 VAC),
840.72W (at 200 VAC)
www.hp.com/go/proliant-energy-
653.08W (at 200 VAC)
50° to 95° F (10° to 35° C) at sea level with an
altitude derating of 1.8°F per every 1000 ft (1.0°C
per every 304.8 m) above sea level to a maximum
of 10,000 ft (3048 m), no direct sustained
sunlight. Maximum rate of change is 18°F/hr
(10°C/hr). The upper limit may be limited by the
type and number of options installed.
System performance may be reduced if operating
with a fan fault or above 86°F (30°C).
40° to 140° F (-40° to 60° C)
Maximum rate of change is 36°F/hr (20°C/hr).
10% to 85% relative humidity (Rh), 82.4°F (28°C)
maximum wet bulb temperature, non-
condensing.
10% to 95% relative humidity (Rh), 101.7°F
(38.7°C) maximum wet bulb temperature, non-
condensing.
10,000 ft (3048 m). This value may be limited by
the type and number of options installed.
Maximum allowable altitude change rate is 1500
ft/min (457 m/min).
30,000 ft (9144 m). Maximum allowable altitude
change rate is 1500 ft/min (457 m/min).
Page 44