Technical Specifications - HP ProLiant ML110 Generation 6 (G6) Quickspecs

QuickSpecs

Technical Specifications

System Unit System Unit System Unit System Unit Dimensions (HxWxD) Dimensions Dimensions Dimensions
(with feet)
Weight (approximate) Weight Weight Weight
Input Requirements Input Requirements Input Requirements Input Requirements
(per power supply)
Power Specifications Power Specifications Power Specifications Power Specifications
Power Supply Output Power Supply Output Power Supply Output Power Supply Output
(per power supply)
System Inlet Temperature Operating System Inlet Temperature System Inlet Temperature System Inlet Temperature
Relative Humidity Relative Humidity Relative Humidity Relative Humidity
(non-condensing)
Altitude Altitude Altitude Altitude
DA - 13477
14.38 x 6.9 x 16.8 in (36.52 x 17.5 x 42.6 cm)
Maximum
(all hard drives, power
supplies, and processors
installed)
Minimum
(one hard drive, power
supply, and processor
installed)
Rated Line Voltage
Rated Input Current
Rated Input Frequency
Rated Input Power
To review typical power ratings use the Power Advisor which is available via
the online tool located at URL:
Rated Steady-State Power 300 W (at 100 VAC),
Maximum Peak Power
Non-operating
Operating
Non-operating
Operating
Non-operating
Worldwide — Version 6 — May 6, 2010
HP ProLiant ML110 Generation 6 (G6) HP ProLiant ML110 Generation 6 (G6) HP ProLiant ML110 Generation 6 (G6) HP ProLiant ML110 Generation 6 (G6)
30.53 lb (13.85 kg)
25.13 lb (11.4 kg)
90 to 132 VAC,
180 to 264 VAC
5 A (at 100 VAC),
2.5 A (at 200 VAC)
47 to 63 Hz
400 W (at 100 VAC),
400 W (at 200 VAC)
http://www.hp.com/go/hppoweradvisor
300 W (at 200 VAC)
300 W (at 100 VAC),
300 W (at 200 VAC)
10° to 35°C (50° to 95°F) at sea level with an
altitude derating of 1.0°C per every 304.8 m
(1.8°F per every 1000 ft) above sea level to a
maximum of 3048 m (10,000 ft), no direct
sustained sunlight. Maximum rate of change is
10°C/hr (18°F/hr). The upper limit may be
limited by the type and number of options
installed.
System may shut down if operating with a fan
fault or above 42°C °(107.6°F).
-35° to 65°C (-31° to 149°F). Maximum rate of
change is 20°C/hr (36°F/hr).
10% to 90% relative humidity (Rh), 28°C
(82.4°F) maximum wet bulb temperature, non-
condensing.
10% to 95% relative humidity (Rh), 38.7°C
(101.7°F) maximum wet bulb temperature, non-
condensing.
3048 m (10,000 ft). This value may be limited by
the type and number of options installed.
Maximum allowable altitude change rate is 609
m/min (2000 ft/min).
9144 m (30,000 ft). Maximum allowable
altitude change rate is 609 m/min (2000 ft/min).
Page 27