Pioneer DVR-560HX-K Operating Instructions Manual page 144

The Initial Setup menu
18
Setting
HDMI Output
Screen
Resolution
• Depending on the connected device some settings may not be available.
• If you choose a setting that is incompatible with your TV you may not be able to see any picture at all. In this case,
press  OPEN/CLOSE while holding down the  (Stop) button on the front panel to switch the setting (this also
switches Component Video Out on page 137 to the default setting).
• If you have the Colour set to YCbCr 4:2:2, you cannot select 720 x 576i (720 x 480i).
4:3 Video Output Full
Colour
• Depending on the connected device some settings may not be available.
• When a DVI device is connected, the YCbCr 4:2:2 and YCbCr 4:4:4 options are not available.
• You cannot choose YCbCr 4:2:2 when the Screen Resolution is set to 720 x 576i (720 x 480i).
Audio Output
This setting is not available when a DVI device is connected.
144
En
Options Explanation
(only available when an HDMI device is connected)
1920 x 1080p Constant 1920 x 1080p output.
1920 x 1080i Constant 1920 x 1080i output.
1280 x 720p Constant 1280 x 720p output.
720 x 576p Constant 720 x 576p output (when setting the Input Line
System to 525 System, video is output in 720 x 480p).
(720 x 480p)
Constant 720 x 576i output (when setting the Input Line
720 x 576i
System to 525 System, video is output in 720 x 480i).
(720 x 480i)
Select if your HDMI TV allows you to change the aspect ratio.
Normal Select if your HDMI TV does not allow you to change the
aspect ratio. 4:3 video will be shown with bars on each side.
Use if colours are weak and black appears to 'float' on the
RGB (0–255)
RGB (16–235) setting.
RGB (16–235) Use this setting if colours appear overly rich and the black
too deep on the RGB (0–255) setting.
YCbCr 4:2:2 The video signal is output as a YCbCr 4:2:2 component
signal. This is the standard setting for HDMI-compatible
devices.
YCbCr 4:4:4 The video signal is output as a YCbCr 4:4:4 component
signal.
Dolby Digital, MPEG and DTS sources are output as a
Auto •
bitstream signal. However, depending on the Audio Out
setting, number of audio channels, and the HDMI-connected
device, Linear PCM audio may be output.
All audio signals are converted to Linear PCM (except DTS).
PCM
Select if the connected device is compatible with bitstream
Bitstream
Priority audio.